Service note for JA-111I BUS LED indicator RGB This product is a component of the JABLOTRON JA-100 alarm system. It serves for optical indication of status. The colour of the indication is optional by means of the connection, e.g. the indicator can indicate the operated output in two colours (red...
JA-111I (0)
Too much choice? Chat or call us at 085-0160316
There are no products in these categories. Shop on.
Service note for JA-111I
BUS LED indicator RGB
This product is a component of the JABLOTRON JA-100 alarm system. It serves for optical indication of status. The colour of the indication is optional by means of the connection, e.g. the indicator can indicate the operated output in two colours (red / green). The product is intended to be installed by a trained technician with valid Jablotron certificate.
Installation
1. Open the indicator cover by loosening the four snap clips using a suitable flat-blade screwdriver, turning it in the direction of arrows.
2. Loosen the snap clip (1) and remove the plate.
Picture: 1 - click clamp of the plate; 2 - signal light of the indicator; 3 - hole to be broken open for supply cable; 4 - connection terminals
3. Pull the supply cable through the hole made (3) and attach the indicator backplate at the selected location.
4. Snap the indicator plate back in.
5. Connect the cable to the terminals (4) according to the chosen colour for indication by signal light (2), see table:
+U supply of voltage of 12 V
R red red light, if closed to GND
G green green light, if closed to GND
B blue blue light, if closed to GND
Y yelow yellow light, if closed to GND
6. After turning on the system, test the operation.
7. Put the indicator cover on.
Function
The indicator is designed for indication indoors, including outside the monitored area. If it is installed outside the monitored area, the voltage conducted at +U terminal (if tapped from the system BUS) must be protected against short circuits, e.g. with a JA-110T module of bus isolator.
Figure: example of connection for a two-colour indication of status of the PG output
Picture: dimensions of a JA-111I indicator.
Technical parameters
Power supply 12 V (9 ...15 V)
Current consumption for standby (LED on / off) 5 mA / 0 mA
Current consumption for cable selection 5 mA
Dimensions 62 x 36 x 27 mm
Environment compliant with EN 50131-1 II. indoors, general
Operating temperature range -10 to + 40 °C
Note: Although this product contains no hazardous materials, do not dispose of it in the domestic waste, but dispose of it at the collection point intended for electronic waste.